This video describes the symptoms of a bad foot pedal sensor board and shows the steps on how to replace the sensor board.
Key times in the video:
- 1:50 disconnect the power to the trolling motor
- 2:11 remove the screws from the bottom of the foot pedal
- 2:59 need to unplug the power cable to the sensor board
- 3:16 pull the power cable out of the main board
- 4:10 remove the potentiometer from the speed control knob
- 5:43 take off the top part of the foot pedal
- 5:58 remove the top of the foot pedal
- 7:16 refasten the potentiometer to the speed control knob
- 8:39 tighten the two screws fir the main control panel
- 9:10 test the potentiometer for the speed control
