Video Guide: Ultrex Transducer and Ethernet Cable Routing Tips

This video will show you how to properly route Minn Kota Ultrex trolling motor transducer and ethernet cables to avoid damage and electronic interference.

For general installation instructions for Minn Kota Ultrex, visit Minn Kota Ultrex Installation Overview | Trolling Motor Install

Key times in the video:

  • 0:00 Intro
  • 0:22 Tools
  • 1:19 Anchor upper end of Cables
  • 1:56 Create a working Loop
  • 2:33 Anchor cables at bottom of the Coil Cord
  • 3:00 Direct Cables outboard of Coil Cord Cover and attach cables to Monoarm
  • 4:06  Test Cable Position before tightening
  • 4:30 Clean up Loose Cables and final tightening
  • 4:55 Discuss final rigging

Was this article helpful?
10 out of 14 found this helpful

Articles in this section