MEGA Live 1 (1st Generation) Compatibility

MEGA Live 1 Imaging (1st Generation) is compatible with select Fish Finders and Minn Kota trolling motors. Compatibility depends on the Fish Finder model, supported sonar capabilities, and mounting configuration.

Pro Tip: Be sure to install the MEGA Live Mask. Installation instructions are available in the Resources section below.

Jump To:

Compatible Fish Finders

MEGA Live 1 is compatible with the following Fish Finders:

  • A Series: All models
  • X Series: All models
  • APEX: All models
  • XPLORE: All models
  • SOLIX G3: All models
  • HELIX G3N: 8, 9, 10, and 12 models with MEGA Side Imaging or MEGA Down Imaging
  • HELIX G4N: 7, 8, 9, 10, 12, and 15 models with MEGA Side Imaging or MEGA Down Imaging

Note: HELIX models, SOLIX G1, and SOLIX G2 are not compatible with MEGA Live 2. This restriction applies to MEGA Live 2 and should not be confused with MEGA Live 1 compatibility.

Note: Compatible HELIX models require an AS EC QDE Ethernet Adapter, item# 720074-1.

Compatible Trolling Motors

MEGA Live 1 Imaging transducers can be mounted on the following Minn Kota trolling motors:

  • Ultrex
  • Ultrex QUEST
  • Fortrex
  • Maxxum
  • Edge

Third-Party Mounting Options

If you do not have a compatible trolling motor, a third-party mounting pole may be used for MEGA Live 1.

Ice Fishing Compatibility

MEGA Live 1 can also be used for ice fishing with the dedicated MEGA Live Ice Adapter Kit.

Resources

Was this article helpful?
0 out of 0 found this helpful

Articles in this section

See more