Terrova Bluetooth i-Pilot Upgrade Kit Installation (2017-2023)

i-Pilot is available as an upgrade kit. Some Terrova models do not come with i-Pilot installed. If you would like to add i-Pilot to your motor, you can use the steps below.

• Upgrade Kits
• Tools and Resources Required
• Installation

Upgrade Kits

Riptide Terrova i-Pilot Upgrade Kit, item number 2774150 (compatible with all Riptide Terrovas (2017-2023))

NOTE: These instructions cover accessory installation only. Click here to download the complete owner’s manual.

Tools and Resources Required

• #2 Phillips Screwdriver
• 30-45 Minutes

Installation

1. Use the #2 Phillips Screwdriver to remove the 4 screws that secure the control box cover and remove the control box cover.
   
2. If AutoPilot was installed disconnect the Network Accessory Plug from the AutoPilot Board and remove the AutoPilot Board and Compass Assembly.
   
3. Connect the i-Pilot Controller Accessory Plug to the motor Network Accessory Plug.
   
4. Place the i-Pilot Controller/Cover Assembly on the Control Box.
5. Install the 4 Screws that secure the i-Pilot Controller/Cover Assembly to the Control Box.