Power your Legacy i-Pilot Remote On and Off

Legacy_i-Pilot_Remote_Differences.png

To Power on the Remote

Press any button. The icons on the screen will light up. If the all of the icons appear and then turn off after 3 seconds, the remote is not able to communicate with the motor. Make sure the motor is powered on. If your motor is powered on, you can try pairing the remote to the motor with the link below.

 

To Power Off the Remote

To turn the remote off press and hold the Record/PauseLegacyIP-RecordPause.png button for 3 seconds.The remote will automatically turn itself off thirty minutes after the last button press if a learned i-Pilot controller is powered up and within transmitting range. The remote will turn off after three seconds if the i-Pilot controller is powered down or out of transmitting range.

Resources

Was this article helpful?
0 out of 0 found this helpful

Articles in this section

See more