Bluetooth Talon Modes

The Talon operates in three different modes. Each Mode is designed for a specific on water scenario and changes the anchoring behavior of the Talon when it deploys. Talon is capable of anchoring in most conditions and it is important to select the right anchoring mode. The three different Mode functions are:

  1. Standard Mode - Standard Mode is the default anchoring Mode for Talon. When put in Standard Mode, the Mode Indicator LED in the Indicator Panel will toggle between red and green and then turn off. In Standard Mode, Talon's Auto Deploy will operate with maximum down-force with a complete Auto-Drive  cycle of three hits spaced at three seconds apart.
  2. Soft Bottom Mode - In Soft Bottom Mode, the Mode Indicator LED will be lit green on the Indicator Panel. In Soft Bottom Mode, the Auto Deploy will operate at a reduced power with a single hit.
  3. Rough Water Mode - In Rough Water Mode, the Mode LED Indicator on the Indicator Panel will be lit red. In Rough Water Mode, the Auto Deploy will operate with maximum down-force with three Auto-Drive cycles of three hits each, spaced 3 seconds apart. The three Auto-Drive cycles will be spaced at 10 second intervals.

 

BT_Talon-_Modes.png
Notice-Soft-Bottom.png
Notice-Power_Loss.png

Toggle the Mode from the Indicator Panel

  1. The Mode can be toggled from the Indicator Panel by selecting the Mode BT_Talon-Mode_Button.png button. The Mode Indicator LED displays the Mode that the Talon is currently set to. Press the Mode BT_Talon-Mode_Button.png button to toggle to the desired Mode.BT_Talon_Control_Panel-_Mode_Selection.png
  2. When no color is present on the LED, the Talon is in Standard Mode. When the LED is Green, the Talon is in Soft Bottom Mode. When the LED is Red, the Talon is in Rough Water Mode.

Toggle the Mode from the Remote

  1. The Mode can be toggled from the Remote by selecting the Anchor Mode BT_Talon-Anchor_Mode_Button.png button. The Mode LED displays the Mode that the Talon is currently set to. Press the Anchor Mode BT_Talon-Anchor_Mode_Button.png button to toggle to the desired Mode.
  2. When the Talon is put in Standard mode, the LED will flash red and green and then turn off. When the LED is Green, the Talon is in Soft Bottom Mode. When the LED is Red, the Talon is in Rough Water Mode.

BT_Talon_Remote-_Mode_Selection.png

Resources

Was this article helpful?
2 out of 2 found this helpful

Articles in this section

See more