Clear Pairing from Bluetooth Talons, Bluetooth Talon Remotes, and Mobile Devices (2018-present)

The Talon was designed so that all paired devices can be cleared from memory.

Clearing Paired Remotes or Devices from the Talon

  1. Retract the anchor on the Talon by pressing the Up button.
    BT_Talon_Control_Panel-Deploy_Retract_Control_Panel.png
  2. Turn the power to the Talon "off". You can turn off the power to the Talon by pulling the fuse.
    Talon_Notification_alarm.png
  3. While holding in the Up button on the Indicator Panel, restore power to the Talon. You will hear a long steady tone.
  4. After the steady tone stops, release the Up button. A series of fast beeps will be heard.
  5. The Talon memory is now clear of all previously paired devices.

Clearing Paired Talons from the Remote
Talon_Remote_labeled.png
Notice-putting_the_remote_into.png

  1. Press and hold the Up button and the Down button on the Remote at the same time until the Talon Selection LEDs on the Remote begin to scroll, release the buttons.
  2. The Remote will go into Pairing Mode for 30 seconds.
  3. Once Pairing times out all Talons will be cleared.

Clearing Paired Talons from Android
Clear_Android.png

  1. Open your Bluetooth settings on your device.
  2. Tap on the gear icon next to the Talon you want to unpair.
  3. Tap "Unpair".

Clearing Paired Talons from iOS
Clear_iOS.png

  1. Open your Bluetooth settings on your device.
  2. Tap on the "i" icon next to the Talon you want to unpair.
  3. Tap "Forget This Device".

Pairing Instructions for your Remote or Controller

Resources

Was this article helpful?
1 out of 1 found this helpful

Articles in this section