Powering your i-Pilot or i-Pilot Link Remote On and Off (Bluetooth and Legacy Remotes (2007-2023))

The instructions below will walk you through turning your Bluetooth or Legacy i-Pilot and i-Pilot Link remote on and off.

  • To power on the remote, press the OK button once.
  • To power off the remote, press and hold the OK button for 3 seconds.

Bluetooth i-Pilot Remote
BT_IP_Remote_with_OK_Button.png

  • To Power on the remote, press the OK button once.
  • To Power Off the Remote, press and hold the OK button for 3 seconds.
  • To power on the remote, press the OK button once.
  • To power off the remote, press and hold the OK key.

Legacy i-Pilot Remote
Legacy_i-Pilot_Remote_Differences.png

  • To Power the remote on, press any button. The icons on the screen will light up. If the all of the icons appear and then turn off after 3 seconds, the remote is not able to communicate with the motor. Make sure the motor is powered on. If your motor is powered on, you can try pairing the remote to the motor with the link below.
  • To Power Off the remote, press and hold the Record/Pause button for 3 seconds. The remote will automatically turn itself off thirty minutes after the last button press if a learned i-Pilot controller is powered up and within transmitting range. The remote will turn off after three seconds if the i-Pilot controller is powered down or out of transmitting range.

Resources

Was this article helpful?
37 out of 62 found this helpful

Articles in this section