Freshwater and Riptide Motor Lower Unit Touch-Up Paint Procedures

Lower Unit Paint Maintenance

Important: Always follow the manufacturer's instructions and safety guidelines for each product listed below.

1. Remove all loose paint
   1. Remove any loose paint by scraping it off.
   2. Sand the area to be painted with a medium grit sandpaper and blend in areas where the paint and substrate meet.
2. Clean the area to be painted (VERY IMPORTANT)
   1. A strong cleaner (paint thinner) that removes dirt and oils and does not leave any residue will work best.
   2. Before painting wiping the area with isopropyl alcohol to remove any remaining residues and moisture.
3. Apply Primer Coating
   1. Use an epoxy-based primer. This will give the strongest adhesion and corrosion resistance.
   2. Allow primary to dry completely per the manufacturer instructions.
4. Apply Final Coating
   • Use an Acrylic based top coat. Acrylic spray paints offer UV resistance as well as durability. Again, the surface should be clean, dry, and free of any residues.