Using the One-Boat Network App to Control your Bluetooth Talon (2018-present)

The One-Boat Network App can be used to control your Minn Kota shallow water anchor. The Anchor Application is dynamic and will change depending on if you are connected to a Talon or Raptor shallow water anchor. You must first select your shallow water anchor source.

• Pair the Mobile Device to the Talon
• Select Anchor Source
• Talon One-Boat Network App Buttons
• Customizing the Talon Settings with the One-Boat Network App

Pair the Mobile Device to the Talon

Once you have signed in to the One-Boat Network App, the app will walk you through connecting your mobile device to your Humminbird and Minn Kota devices.

1. Enable Bluetooth on the Mobile Device
2. Open the Settings menu.
3. Select Bluetooth.
4. Select On.
5. Keep the Bluetooth menu open and proceed to the next procedure.
   • Single Talon
     • Apple iOS
       1. Enable Pairing Mode on the Talon: Press and hold the Up and Down buttons on the Talon for two seconds. The depth lights will illuminate in a blue pattern to indicate pairing mode is active.
       2. Navigate to the Bluetooth Settings on your mobile device.
       3. Select BT Talon under the Other Devices. It may take a moment for the Talon to appear in the menu. Once your Talon is paired with your device, BT Talon will display under My Devices in the iOS Bluetooth settings.
     • Android
       1. Enable Pairing Mode on the Talon: Press and hold the Up and Down buttons on the Talon for two seconds. The depth lights will illuminate in a blue pattern to indicate pairing mode is active.
       2. Navigate to the Bluetooth Settings on your mobile device. Select the Scan button to begin the search for your device.
       3. Select BT Talon under Available devices. It may take a moment for the Talon to appear in the menu. Once your Talon is paired with your device, BT Talon will display under Paired devices in the Android Bluetooth Settings.
   • Dual Talons

     If you are connecting dual Talons, the Talons must be paired together before connecting them to your mobile device. Use the following instructions to pair the Talons together, then follow the instructions for the single Talon to pair it to your mobile device.

     1. Place one Talon in Pairing Mode: Press and hold the Up and Down buttons on the Talon for two seconds. The depth lights will illuminate in a blue pattern to indicate pairing mode is active.
     2. Place second Talon in Pairing Mode: Press and hold the Up and Down buttons on the Talon for two seconds. The depth lights will illuminate in a blue pattern to indicate pairing mode is active.
     3. Both Talons will beep three times once they are connected, and then both Talon mode lights will flash green.
     4. On the starboard Talon, press the Up button to set that Talon as starboard. The starboard Talon’s mode light will temporarily illuminate green and the port Talon’s mode light will illuminate red to indicate that the Talon positions are set.

Select Anchor Source

1. Tap the Settings icon under the One-Boat Network banner at the top right of the app.
   
2. Select Anchor Source.
   
3. Tap the radio button for Talon.
   

Talon One-Boat Network App Buttons

The One-Boat Network App allows you to control and update the Talon from your paired mobile device.

Deploy: Double tap the Auto Down button.
Pause: While the anchor is deploying or retracting, tap the Pause button once. Tap the Auto Down button again to resume deployment, or tap the Auto Up button again to resume retraction.
Retract: Tap the Auto Up button once.

Customizing the Talon Settings with the One-Boat Network App